BIGGER shows you the detection standard of BIGGER adhesive.
BIGGER shows you the detection standard of BIGGER adhesive.
Main physical and chemical properties of BIGGER adhesive:
Storage life:
Under certain conditions, BIGGER adhesive can maintain the operation performance and the specified strength of storage and operation time.
The maximum time interval between the adhesives and the bonding.
Initial cure time:
To be able to remove the strength of the bond, including moving parts from the fixture.
bonding strength:
Under the action of external forces, the adhesives in the adhesive are required to be damaged by the interface of the adhesive or the vicinity of the adhesive.
shear strength:
The unit is expressed in MPa(N/mm2) for the shear force that the unit can withstand when the adhesive is damaged.
Total curing time:
When BIGGER adhesive is mixed, the final mechanical properties need to be unevenly separated.The joint is subjected to the maximum load that can be sustained when the force is not evenly split.Because loads are concentrated on two edges or one edge of the rubber layer.The unit length instead of the unit area, the unit is KN/m.
Tensile strength:
The tensile strength is also called uniform pull strength.Refers to the tensile force exerted by the unit area when the adhesive force is destroyed, expressed by MPa(N/mm2).
Peel strength:
The peel strength is the maximum load that can be borne by the unit width under the specified stripping condition.The units are expressed in KN/m.
GUANGDONG ORIENT YIGE NEW MATERIAL Co.,LTD, has been developing and has more than 200 products in the past 23 years.Our brand has: BIGGER environmental protection shoe adhesive/glue,BIGGER water-based PU adhesive/glue, BIGGER environmental protection spray adhesive/glue, BIGGER hot melt adhesive/glue,BIGGER all purpose adhesive/glue and so on product.
Main physical and chemical properties of BIGGER adhesive:
Storage life:
Under certain conditions, BIGGER adhesive can maintain the operation performance and the specified strength of storage and operation time.
The maximum time interval between the adhesives and the bonding.
Initial cure time:
To be able to remove the strength of the bond, including moving parts from the fixture.
bonding strength:
Under the action of external forces, the adhesives in the adhesive are required to be damaged by the interface of the adhesive or the vicinity of the adhesive.
shear strength:
The unit is expressed in MPa(N/mm2) for the shear force that the unit can withstand when the adhesive is damaged.
Total curing time:
When BIGGER adhesive is mixed, the final mechanical properties need to be unevenly separated.The joint is subjected to the maximum load that can be sustained when the force is not evenly split.Because loads are concentrated on two edges or one edge of the rubber layer.The unit length instead of the unit area, the unit is KN/m.
Tensile strength:
The tensile strength is also called uniform pull strength.Refers to the tensile force exerted by the unit area when the adhesive force is destroyed, expressed by MPa(N/mm2).
Peel strength:
The peel strength is the maximum load that can be borne by the unit width under the specified stripping condition.The units are expressed in KN/m.